Found 5 images also using this tag.

Emergency strobe light

The emergency strobe light consists of 33 high intensive 5 mm LEDs and control circuit. It has four sequences, and can be set on a single sequence or to cycle through every fifth second. When selecting a sequence manually it is stored in EEPROM and continues on power-up. If an external controlling unit is plugged in; the internal sequences will stop and the external unit is in control. This makes it possible to synchronize multiple units. LEDs are driven by a PWM output, module is powered by 9-24V.

Read more...

Warning strobe light controller

The warning lights controller has two PWM driven outputs, that each can handle a load of 3 amps. It has five sequences, and can be set on a single sequence or to cycle through. When selecting a sequence manually it is stored in EEPROM and continues on power-up. Much of the hardware and software is based on the Emergency strobe light project. Can be used to drive the Warning lights with 10mm LEDs project. Powered by: 9-24V.

Read more...