Found 17 images also using this tag.

Fan and temperature controller with LCD

The module uses an LM35 sensor for measuring the temperature, it is a pre-calibrated IC with output voltage linearly-proportional to the Centigrade temperature. This is read directly by the internal AVR ADC, and turned into actual degrees with a simple calculation. The fan is powered by an PWM output, giving it variable speed. Set points for the fan and alarm can be adjusted and is saved to EEPROM.

Read more...

Light sensor with LED display

This module measures light intensity and shows it on a scale from 0 to 782 on the LED display. By multiplying that value with 5, and then divide by 127 you get the light intensity in µW/cm2. If the light intensity rises over or falls below (configurable) the set point; the output activates, with a hysteresis of +-25. The module has two outputs; a constant and a pulse. The constant output can be used to drive e.g. a relay, while the pulse can communicate with other equipment. Powered by: 9-24V.

Read more...

Mood light (RBG) with 100 mA outputs

This simple mood light controller has three PWM controlled channels; red, green and blue. Each capable of delivering 100 mA, or about five LEDs. This can easily be improved by using a more powerful transistor. I’ve used 3x3 LEDs soldered to a tiny circuit board as the light source, and placed them inside a frosted glass. A better solution would be to use a powerful RBG LED. Just remember to use another transistor if you want to use bigger LEDs.

Read more...

Mood light (RGB) controller with 500mA outputs

The mood light controller can control all kinds of RGB light, max 500mA pr. channel. The module has no voltage regulator and therefore needs 5V=, and enough current to drive the circuit and the connected LEDs. It very slowly cycles through different colors, fading one LED up or down leaving the previous LED turned on. The module can power Prolight LEDs, like Mood light using 3W Prolight RGB LED.

Read more...