Inside LED strobe controller for car module, with wires connected to pin headers.
Strip board with AVR chip, inside LED strobe controller for car.
Closeup of the circuit board with components, ATmega8 and voltage regulator visible.
Lots of wires connecting everything inside the light sensor.
Closeup of the ATmega8 microcontroller and voltage regulator with heat sink.
Closeup of the ATmega8 microcontroller, and lots of wires.
Inside the emergency strobe, circuit board connected to LEDs, switches and connectors.
Emergency strobe circuit board wired to LEDs, switches, connectors.
Lid on emergency strobe open, showing circuit board, wiring, LEDs, etc.
Schematic drawing of a L78S05CV voltage regulator circuit.
An inside view after everything has been fitted, ATtiny2313 microcontroller, voltage regulator and power transistors visible.
Circuit board in the warning strobe module. Everything connected.
Installing the circuit board and doing some final testing on the warning strobe controller.
Circuit board finished, AVR microcontroller not yet installed. Power transistors and voltage regulator visible.
Last check inside the unit before closing the lid, MAX232, ATtiny2313 and voltage regulator visible.
Inside of the module during assembly, ATtiny2313 microcontroller and voltage regulator installed.
An inside look of Alarm disabling unit #2, voltage regulator with heat sink visible.
A overview of the insides of the alarm disabling unit #2. Voltage regulator has heat-sink.
Circuit board for alarm disabling unit #2, AVR microcontroller not yet fitted.
Some final testing of the circuit board before installing it in the box.
Circuit board for alarm disabling unit #1, AVR ATtiny2313 and optoisolator not yet fitted.
Electronics, computers, tech and other geeky stuff by Thomas Jensen aka Hebron
Content licensed under CC BY-SA 4.0.
Made in Norway
Deployed: 2 days ago