Wires soldered to the back-light switch and reset button in the module heartbeat monitor box.
Aug 31 2017
Inside the module heart beat monitor box.
Switch for LCD back-light, and push-button for alarm reset on module heartbeat monitor.
Backside of the aluminum plate of the rack status panel.
Aug 30 2017
Status panel for the rack box project, with everything mounted.
Laboratory plugs with 5, 13. and 24 V test power in rack status panel.
A simple switch for power jack connection.
Inside the simple switch for power jack connection.
Inside the home made I/O tester. Shows if input gets a positive (green) or negative (red) signal.
Home build input and output tester with 6 channels. Shows if input gets a positive (green) or negative (red) signal.
Home made test power with 5 and 12 volts, ESD ground and laboratory connectors.
A fuse, indicator LED and switch for the kitchen cabinet LED lights.
Schematic drawing for electronic light switch; with AVR ATtiny2313.
Nov 6 2007
Front plate of the status panel, image taken April 2007.
Apr 14 2007
A couple of more things mounted on the status panel, image taken January 2007.
Jan 6 2007
About half done with mounting LEDs, buttons and switches in the status panel.
Aug 18 2006
Almost done with the left side and top of the status panel.
Aug 14 2006
Switch for turning the car lights controller on and off.
Jul 9 2008
Switch and RGB LED installed in my old cars dashboard, for use with car lights controller.
Installing a switch and RGB LED in my old cars dashboard.
Mar 14 2008
Toggle switch in an existing hole on the SOS station, rubber gaskets in the unused holes.
Apr 17 2017
Toggle switch on the walking car, to turn the emergency light on and off.
Apr 2 2017
Dec 31 2007
Mar 5 2006
Jul 27 2005
Most of the time I run the fan in the home offce on level 3, at full speed it moves about 200 cubic feet of air per minute.
Oct 8 2015
Light sensor; with LED display, switches, d-sub connector and light sensor TSL250R.
Jul 27 2015
LED display and switches on the front of light sensor.
Front of the light sensor; with LED display, switches and light sensor TSL250R.
Close up of the parallel I/O module front, with switches and LEDs.
Front of the parallel I/O module, with switches and LEDs.
Back of the emergency strobe, with sequence selector and indicator, power and external signal connectors.
A front view of the parallel I/O module with indicator LEDs.
The parallel I/O module installed and in use in the rack box project.
May 5 2006
Warning strobe light controller, connected to four warning lights with 10mm high intensive LEDs.
May 27 2008
Front of the warning strobe controller during construction. Power connector, switches and status LED installed.
Mar 22 2008
Showing current light value, the light sensor TSL250R can be seen poking out on the top.
Apr 10 2007
Emergency strobe light complete, showing backside with on/off and sequence selector switch and indicators.
Sep 14 2007
Electronics, computers, tech and other geeky stuff by Thomas Jensen aka Hebron
Content licensed under CC BY-SA 4.0.
Made in Norway
Deployed: 1 month ago