Voltage regulator with heat sink on car lights controller circuit board.
Aug 31 2017
AVR ATtiny2313 microcontroller on car lights controller circuit board.
Inside the car lights controller, with additional output transistors in a separate box.
Green light lit on RGB LED on heat sink.
Aug 30 2017
Red light lit on RGB LED on heat sink.
Blue light lit on RGB LED on heat sink.
RGB LED mounted on a heat sink = mood-light.
Three power transistors mounted on a heat sink.
Apr 8 2006
Electronic switch module with d-sub and power jack connectors on bottom.
Aug 1 2017
Heat-sink for the voltage regulator on electronic switch module.
Electronic switch module complete.
Inside the warning lights controller, with wires connected to pin headers.
Circuit board for car lights controller, with AVR ATtiny2313 microcontroller and optocoupler.
Mar 4 2008
LEDs and heat sink on stack lights controller module.
Sep 17 2015
Stack lights controller module.
Stack lights controller done, with internal power transistors.
Apr 12 2006
Inside LED strobe controller for car module, with wires connected to pin headers.
May 23 2009
Strip board with AVR chip, inside LED strobe controller for car.
May 22 2009
Light switch module mounted on wall. Heat-sink used for 5V voltage regulator.
Apr 10 2007
Initial testing of the light switch module.
Feb 18 2007
Mounted push-buttons, LED holders and heat-sink on the light switch module.
Feb 17 2007
RGB LED mounted on a heat-sink, red light lit.
Apr 19 2007
RGB LED mounted on a heat-sink, blue and red light lit.
RGB LED mounted on a heat-sink, with glass ball on top. Red light lit.
Apr 11 2007
RGB LED mounted on a heat-sink, with glass ball on top. Green light lit.
RGB LED mounted on a heat-sink, with glass ball on top.
A white Prolight LED mounted on a heat-sink.
Closeup of the circuit board with components, ATmega8 and voltage regulator visible.
Jul 27 2015
Lots of wires connecting everything inside the light sensor.
Closeup of the ATmega8 microcontroller and voltage regulator with heat sink.
Closeup of the ATmega8 microcontroller, and lots of wires.
Circuit board in the emergency strobe, with ATtiny2313 and a couple of optocouplers.
Inside the emergency strobe, circuit board connected to LEDs, switches and connectors.
Emergency strobe circuit board wired to LEDs, switches, connectors.
Circuit board is wired and mounted to the case lid on emergency strobe.
Lid on emergency strobe open, showing circuit board, wiring, LEDs, etc.
An inside view after everything has been fitted, ATtiny2313 microcontroller, voltage regulator and power transistors visible.
Mar 22 2008
Circuit board in the warning strobe module. Everything connected.
Installing the circuit board and doing some final testing on the warning strobe controller.
Circuit board finished, AVR microcontroller not yet installed. Power transistors and voltage regulator visible.
Last check inside the unit before closing the lid, MAX232, ATtiny2313 and voltage regulator visible.
Apr 29 2007
Inside of the module during assembly, ATtiny2313 microcontroller and voltage regulator installed.
An inside look of Alarm disabling unit #2, voltage regulator with heat sink visible.
May 19 2007
A overview of the insides of the alarm disabling unit #2. Voltage regulator has heat-sink.
Circuit board for alarm disabling unit #2, AVR microcontroller not yet fitted.
An inside look of Alarm disabling unit #1, heat-sink for the voltage regulator is visible.
Mar 2 2007
Electronics, computers, tech and other geeky stuff by Thomas Jensen aka Hebron
Content licensed under CC BY-SA 4.0.
Made in Norway
Deployed: 1 month ago